BM-500
Description
Premium quality Armature Banding Machine model BM-500 can accommodate a variety of small, medium and large armatures for the starter motor manufacturing industry. The BM-500 applies fiberglass tape under high tension, up to 220 lbs. (100 kg), to the wire winding turns outside of the lamination stack so to prevent “flare out” of the end turns, due to centrifugal forces at high rotational speed. Then the armature is heat-baked and the tape becomes a solid shield over the wire. A traversing carriage on the bed of the Banding Machine allows for a complete placement control and layering of the tape onto the windings.
Approximate capacity: 60-80 pcs/hr
Features
- High banding tension (easily adjustable )
- Digital Tension Readout
- Smooth traverse carriage movement for effortless layering
- Pneumatic carriage locks for precise single position placement
- Simple, robust design
- Computerized control of the entire process; warning is issued if the banding process is not successful
- Readjustment time is only ten minutes
- User-friendly interface
- LCD display of all technical and geometrical parameters and current status of the process
- Self-diagnostic troubleshooting system
Specifications
| Commutator diameter, mm | 28 to 60 |
| Armature’s shaft length, mm | 180 to 500 |
| Electrical power, Volt; Hz | 220; 60 (Other voltages available on request) |
| Air pressure supply, bar | 6 |
| Productivity , pcs/hour | up to 100 |